As the electronic part is packed in 16-SOIC (0.154, 3.90mm Width), international shipping is convenient. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. 2:1 is the number of circuits in the multiplexer and demultiplexer. Operating temperature extended to -55°C~125°C TA. Total terminations are 16. The electronic part provides high-quality output because it has 2 channels. Powered by a 4.5V voltage supply, the electrical part should be switched on and run. The electrical component body receives 16 pins. Circuits based on SPDT switching are used to construct these analog switch ics. There are 3 circuits in this switch device. Try searching with M74HCT405 to find analog multiplexer variants. An switch multiplexer with 120Ohm internal resistance has a value of 120Ohm. Datasheets for 16 pin functions are available upon request. The analogue multiplexer in this example is a typical Multiplexer or Switches. Multiplexers should not be powered above 5.5V in normal situations. The analog switch ic is of the Dual supply type and is cost-effective. The lowest voltage the electronic part should receive is 4.5V. An operating current of 8μA would be sufficient for this switch device. Despite this switch device's dual supply capability, its voltage should not exceed 6V. It is recommended that you attach at least 1V to your dual power supply. An analog IC with the number SINGLE-ENDED MULTIPLEXER is integrated into this board. 5V operating voltages can be used with this electrical part. Operating the 6 inputs requires 6 inputs. There are 120MHz bandwidths for data transfer.