Shipping overseas is convenient due to the electrical component's packing in 12-UFQFN. This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). Surface Mount is where this multiplexer is located. Multiplexers and demultiplexers have a ratio of 3:1. Operational temperature extended around -55°C~125°C TA. In total, there are 12 terminations. The electronic part delivers high-quality output through its 3 channels. With a 2.7V voltage supply, the electrical component should be turned on and run. A total of 12 pins are injected into the body of the electronic part. These analog multiplexers are built based on SP3T switching circuits. Try searching with STG3856 to find analog multiplexer variants. An switch multiplexer with 1Ohm internal resistance has a value of 1Ohm. Datasheets for functions of 12 pins are available. The analog multiplexer shown here is a typical Multiplexer or Switches. Users should never supply a voltage higher than 4.3V to a switch device. Single supply type digital switch with a low cost. It is recommended to use 1.4V as the lowest voltage for the electrical part. The switch device would be able to operate with 50nA current. A voltage of 1.65V~4.3V is required for this switch device, which drains from a single voltage source. Putting voltage greater than 50nA on the multiplexer may cause damage. With a DIFFERENTIAL MULTIPLEXER analog IC integrated into the board. Among the inputs that can be operated are the 2 inputs. There is 1Ohm Drain to Source resistance on this electronic part. Multiplexer ics with 6 outputs are available.