STM32L052K8T6  Description

The ultra-low-power STM32L052x6/8 microcontrollers incorporate the connectivity power of the universal serial bus (USB 2.0 crystal-less) with the high-performance ARM? Cortex?- M0+ 32-bit RISC core operating at a 32 MHz frequency, a memory protection unit (MPU), high-speed embedded memories (64 Kbytes of Flash program memory, 2 Kbytes of data EEPROM and 8 Kbytes of RAM) plus an extensive range of enhanced I/Os and peripherals.

The STM32L052x6/8 devices provide high power efficiency for a wide range of performance. It is achieved with a wide choice of internal and external clock sources, an internal voltage adaptation, and several low-power modes.

The STM32L052x6/8 devices offer several analog features, one 12-bit ADC with hardware oversampling, one DAC, two ultra-low-power comparators, several timers, and one low-power timer (LPTIM), three general-purpose 16-bit timers, and one basic timer, one RTC and one SysTick which can be used as timebases. They also feature two watchdogs, one watchdog with independent clock and window capability and one window watchdog based on bus

clock.

STM32L052K8T6  Features

Ultra-low-power platform

– 1.65 V to 3.6 V power supply

– -40 to 125 °C temperature range

– 0.27 μA Standby mode (2 wakeup pins)

– 0.4 μA Stop mode (16 wakeup lines)

– 0.8 μA Stop mode + RTC + 8 KB RAM retention

– 88 μA/MHz in Run mode

– 3.5 μs wakeup time (from RAM)

– 5 μs wakeup time (from Flash memory)

? Core: ARM? 32-bit Cortex?-M0+ with MPU

– From 32 kHz up to 32 MHz max.

– 0.95 DMIPS/MHz

? Reset and supply management

– Ultra-safe, low-power BOR (brownout reset)

with 5 selectable thresholds

– Ultra-low-power POR/PDR

– Programmable voltage detector (PVD)

? Clock sources

– 1 to 25 MHz crystal oscillator

– 32 kHz oscillator for RTC with calibration

– High-speed internal 16 MHz factory-trimmed RC

(+/- 1%)

– Internal low-power 37 kHz RC

– Internal multispeed low-power 65 kHz to

4.2 MHz RC

– Internal self-calibration of 48 MHz RC for USB

– PLL for CPU clock

? Pre-programmed bootloader

– USART, SPI supported

? Development support

– Serial wire debug supported

? Up to 51 fast I/Os (45 I/Os 5V tolerant)

? Memories

– Up to 64 KB Flash memory with ECC

– 8KB RAM

– 2 KB of data EEPROM with ECC

– 20-byte backup register

– Sector protection against R/W operation