TL081CN Overview
Packaged in a 8-DIP (0.300, 7.62mm) case, the buffer op amp is ready to use. Op amps are J-FET types of amplifier on the chip. As far as the packaging is concerned, buffer op amp is delivered in a Tube case. During the past two weeks, there have been close to 8 terminations. A total of 8 pins are located on this board. Please take in mind that this instrumentation amplifier should be run at 15V. This particular linear amplifier is a type of Operational Amplifier device, to be precise. The op amp ic has an array of 8 pins on it. In terms of the input offset voltage, instrumentation amplifier rates at 10mV. Through Hole is the recommended mounting type for this linear amplifier. It is recommended that this op amp ic be operated at a temperature no higher than 0°C~70°C for optimal performance. A supply current of 1.4mA can be used to operate this linear amplifier. You should keep the voltage gain at 106.02dB for the time being. The op amp ic has 1 channels on it. The operating supply voltage of the buffer op amp is rated at 18V.
TL081CN Features
8 Pins
supply voltage of 15V
106.02dB voltage gain
TL081CN Applications
There are a lot of STMicroelectronics TL081CN Instrumentational OP Amps applications.
- PDA
- Weighing systems
- RF cable systems
- Laptop
- Inverse/same-phase proportional circuit
- Portable docking station
- Communication
- Communication device
- Television broadcasting equipment
- Automotive sensors
