5962-9080901M2A Overview

Packaged in a LCC case, the buffer op amp is ready to use. An op amp ic of the OPERATIONAL AMPLIFIER type. The op amp is delivered to you in a Bulk case. There is a growing number of terminations approaching the number of 20. The pins on this board total to 20 in total. I would like to remind you that this buffer op amp should be powered by an 5V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. A total of 20 pins are present on the instrumentation amplifier. There is an input offset voltage of 7mV for this buffer op amp. 96.26dB should remain the voltage gain. As far as the device is concerned, buffer amplifier has 4 channels. For the buffer op amp to operate properly, it must be above the temperature of -55°C degrees Celsius. No temperature greater than 125°C should be used. For packing the buffer amplifier, the TUBE-axis is adopted. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 18V. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 18V volts.

5962-9080901M2A Features

20 Pins
supply voltage of 5V
96.26dB voltage gain

5962-9080901M2A Applications

There are a lot of Texas Instruments
5962-9080901M2A Instrumentational OP Amps applications.

• Integrator circuits
• Differentiator circuits
• Logarithmic operation circuits
• Exponential operation circuits
• Multiplication circuits
• Division circuits
• Precision measurement
• Power control
• Information processing
• Weak signal detection