The electronic component is convenient to ship overseas because it is packed in a TSSOP. The advanced packaging method Tube provides high reliability. 4:1 is the ratio between multiplexers and demultiplexers. The operating temperature is extended to around -55°C ~ 125°C (TA). The total number of terminations is 16. As a result of its 2 channels, this electronic component provides high-quality output. An 5V voltage supply should allow the electrical part to be turned on and run. There is an electrical component included in the 16 series. Based on SP4T switching circuits, these analog multiplexers work. The multiplexer consists of 2 circuits. Use 4052 to search for variants of the digital switches. The internal resistance of this digital multiplexer is 240Ohm. Datasheets for functions of 16 pins are available. normally, users should not supply switches with voltages higher than 20V. Analogue multiplexer with a Dual, Single supply type that is cost-effective. A low voltage of 3V should be applied to the electronic component. This multiplexer would work with 80nA current. Using only a single voltage supply, this analog switch requires 3 V ~ 20 V voltage. For this multiplexer, dual supply voltage is feasible, but it should not exceed 9V. A dual power supply should have at least 2.5V voltage attached. With a DIFFERENTIAL MULTIPLEXER analog IC integrated into the board. A voltage of 18V can be used to operate the electronic component. A 8 input needs to be operated. There are various bandwidths available for data transfer. It is not recommended to operate the switches in an environment with a temperature higher than 125°C. Suppliers offer 16-TSSOP packages. 4-bit conductivity is possible. This is electronic component of the -- series.