CD4067BME4 Overview

Shipping overseas is convenient due to the electrical component's packing in 24-SOIC (0.295, 7.50mm Width). To ensure high reliability, a new packaging method Tube is used. In Surface Mount, you'll find this switch device. The ratio between the number of multiplexer and demultiplexer circuits is 16:1. Operational temperature extended around -55°C~125°C TA. In total, 24 terminations have occurred. The electronic part provides high-quality output because it has 16 channels. When the electronic component is given a voltage of 5V, it should be turned on and run. A total of 24 pins are injected into the electrical part body. There are 1 circuits in this multiplexer. Look for analog switch ic variants by searching with CD4067. An switch multiplexer with 240Ohm internal resistance has a value of 240Ohm. The datasheets for the 24 pins explain the functions. There is Multiplexer or Switches analog multiplexer like this in the world. A voltage higher than 18V should not normally be supplied to the switches. The analog switch ic is of the Single supply type and is cost-effective. 3V should be the lowest voltage fed to the electronic component. In order to operate this switch device, it would need a current of 80nA. A voltage of 3V~18V is required for this switch device, which drains from a single voltage source. As far as the outputs go, this switch multiplexer utilizes SEPARATE OUTPUT of them. There are 14MHz bandwidths for data transfer. 16-bit conductivity is possible.

CD4067BME4 Features

16 Channels
80nA Supply Current
Bandwidth: 14MHz
16-Bit

CD4067BME4 Applications

There are a lot of Texas Instruments CD4067BME4 Analog Switches & Multiplexers ICs applications.

• Voice over IP/DSL – Integrated Access Devices, Smart
• Fiber In The Loop (FITL)
• SDH
• Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
• Public switching systems
• FTTH
• High reliability control systems
• T1/E1 Terminals
• USB 1.1 signal switching circuits
• Multi-Line E1 Interface Cards