CD74HC4052PWRG4 Overview

The electrical component comes in 16-TSSOP (0.173, 4.40mm Width) packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tape & Reel (TR) is used. In Surface Mount, you'll find this switch device. In the multiplexer and demultiplexer, 4:1 represents the number of circuits. Operating temperature around -55°C~125°C TA extended. In total, 16 terminations have occurred. A electrical component with 8 channels is capable of high-quality output. When the electronic component is given a voltage of 4.5V, it should be turned on and run. Into the electrical component body are injected 16 pins. On the other hand, analog switches can be constructed using SP4T switching circuits. Circuits number 2 make up this analogue multiplexer. Look for analog switch ic variants by searching with 74HC4052. A 130Ohm internal resistance characterizes this multiplexer. The datasheets for the 16 pins explain the functions. The analog multiplexer shown here is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 6V. A analog switch ic that has a cost-effective Dual, Single supply type. It is recommended to use 2V as the lowest voltage for the electrical part. For this switch, a dual supply voltage is feasible, but it must not exceed 5VFor dual power supplies, a voltage of at least 1V should be attached. Integrated with an analog IC DIFFERENTIAL MULTIPLEXER. It is possible to transfer data over a 185MHz-bandwidth. 4-bit operation is possible.

CD74HC4052PWRG4 Features

8 Channels
Switch Circuit: SP4T
Bandwidth: 185MHz
4-Bit

CD74HC4052PWRG4 Applications

There are a lot of Texas Instruments
CD74HC4052PWRG4 Analog Switches & Multiplexers ICs applications.

• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems
• Sample-and-hold systems
• Communication systems
• Data Acquisition Systems
• Relay Replacement
• Battery Powered Systems
• Existing multiplexer applications (both fault-protected and nonfault-protected)