CD74HC4066PW Overview

The electronic component is convenient to ship overseas because it is packed in a 14-TSSOP (0.173, 4.40mm Width). This high-reliability packaging method uses advanced packaging methods Tube. Surface Mount is where this multiplexer is located. The ratio between the number of multiplexer and demultiplexer circuits is 1:1. Operational temperature extended around -55°C~125°C TA. Total terminations are 14. By its 4 channels, the electronic component provides high-quality output. An 4.5V voltage supply should allow the electrical part to be turned on and run. An electrical component of this type can be found in the 14 series. Based on SPST - NO switching circuits, these analog multiplexers work. Search with 74HC4066 if you are looking for analog multiplexer variants. The internal resistance of this digital multiplexer is 70Ohm. The functions of 14 pins can be found in the datasheets. A analogue multiplexer of this type is a Multiplexer or Switches. It is generally not recommended to supply a voltage higher than 10V to the switch device in normal circumstances. A analog switch ic that has a cost-effective Single supply type. There should be 2V voltage fed to the electrical part below 2V. A voltage of 2V~10V is required to drain this analog switch from a single voltage supply. A voltage higher than 16μA may cause damage to the switch multiplexer. A 200MHz-bandwidth can be used for data transfer. It has a Drain to Source resistance of 25Ohm ohms.

CD74HC4066PW Features

4 Channels
Switch Circuit: SPST - NO
Bandwidth: 200MHz
Drain-to-Source resistance: 25Ohm

CD74HC4066PW Applications

There are a lot of Texas Instruments CD74HC4066PW Analog Switches & Multiplexers ICs applications.

• Channel Banks
• E1 Network Equipment
• Relay Replacement
• Frame Relay Equipment
• RGB switches
• Voice over IP/DSL – Integrated Access Devices, Smart
• Remote wireless modules
• Video signal routing
• Cell phones
• FTTH