As the electronic part is packed in 16-SOIC (0.154, 3.90mm Width), international shipping is convenient. To ensure high reliability, a new packaging method Tape & Reel (TR) is used. Mounted in Surface Mount is this multiplexer. 2:1 is the number of circuits in the multiplexer and demultiplexer. Extended operating temperature around -55°C~125°C TA. In total, 16 terminations have occurred. The electronic part delivers high-quality output through its 3 channels. A 4.5V voltage supply should turn on and run the electronic component. 16 pins are injected to the electronic part body. Unlike digital switches, these are based on SPDT switching circuits. A total of 3 circuits make up this switch device. 74HCT4053 can be used to search for analog multiplexer variants. An switch multiplexer with 130Ohm internal resistance has a value of 130Ohm. For functions related to 16 pins, please refer to the datasheets. There is Multiplexer or Switches analog multiplexer like this in the world. An abnormal situation would be for the switch device to be supplied with a voltage greater than 5.5V. The analog switch ic is of the Dual, Single supply type and is cost-effective. There should be 4.5V voltage fed to the electrical part below 4.5V. There is no problem with using dual supply voltage, but it should not exceed 5V. A dual power supply should have at least 1V voltage attached. An analog IC with the number SINGLE-ENDED MULTIPLEXER is integrated into this board. It can operate from 5V operating voltages. The electrical component supports 6 inputs. The data can be transferred over a wide range of bandwidths, called 200MHz bandwidths. 2-bit conductivity is possible.