CD74HCT4316M96G4 Overview

Packed in 16-SOIC (0.154, 3.90mm Width), the electronic component is convenient for shipping overseas. This packaging method provides high reliability because it uses advanced packaging techniques. There is an analog multiplexer mounted in position Surface Mount. The ratio between the number of multiplexer and demultiplexer circuits is 1:1. Operation at a temperature around -55°C~125°C TA. Totally, there are 16 terminations. As a result of its 4 channels, this electronic component provides high-quality output. It is safe to turn on and run the electronic component with a 4.5V voltage supply. An injection of 16 pins is performed into the body of the electrical component. On the other hand, analog switches can be constructed using SPST - NO switching circuits. Try searching with 74HCT4316 if you're looking for variants. It has an internal resistance of 170Ohm. To find out what the functions of 16 pins are, please refer to their datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 5.5V. The digital multiplexer has a low cost Dual, Single supply. In order for the electronic part to function properly, the lowest voltage should be 4.5V. A digital multiplexer may suffer damage if voltage is applied above 16μA. Dual supply volatge is feasible for this multiplexer. But it should not go beyond 5V. In the case of dual power supplies, you should connect at least 1V. Operating voltages of 5V are compatible with the electrical part. 200MHz-bandwidths can be used to transfer data between multiplexers. This electronic part has additional features, such as: ALSO OPERATES WITH 2V TO 10V (VCC-VEE) SUPPLY.

CD74HCT4316M96G4 Features

4 Channels
Switch Circuit: SPST - NO
Bandwidth: 200MHz
Additional Features: ALSO OPERATES WITH 2V TO 10V (VCC-VEE) SUPPLY

CD74HCT4316M96G4 Applications

There are a lot of Texas Instruments CD74HCT4316M96G4 Analog Switches & Multiplexers ICs applications.

• DSUs
• Wireless Local Loop
• E1 Multiplexer
• Cable PC
• Relay Replacement
• SDH
• Existing multiplexer applications (both fault-protected and nonfault-protected)
• High speed data transmission line cards
• DVD-R
• DSLAMs