CY74FCT374ATPC Overview
It is embeded in 20-DIP (0.300, 7.62mm) case. It is contained within the Tubepackage. T flip flop uses Tri-State, Non-Invertedas its output configuration. In the configuration of the trigger, Positive Edgeis used. There is an electric part mounted in the way of Through Hole. A voltage of 4.75V~5.25Vis required for its operation. In the operating environment, the temperature is -40°C~85°C TA. It is an electronic flip flop with the type D-Type. The FPGA belongs to the 74FCT series. The element count is 1 . During its operation, it consumes 200μA quiescent energy. There are 20 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. JK flip flop belongs to 74FCT374 family. An input voltage of 5Vpowers the D latch. There is 5pF input capacitance for this T flip flop. FCTis the family of this D flip flop. There is an electronic part mounted in the way of Through Hole. It is designed with 20 pins. This device exhibits a clock edge trigger type of Positive Edge. It is part of the FF/Latchesbase part number family. An electronic part designed with 8bits is used in this application. Its flexibility is enhanced by 8 circuits. It runs on 5Vvolts of power. The flip flop contains 2ports. If high efficiency is desired, the supply voltage should be kept at 5V. This T flip flop features a maximum design flexibility due to its output current of 64mA. There are 3 output lines in this JK flip flop. This can be achieved at a frequency of 250MHz.
CY74FCT374ATPC Features
Tube package
74FCT series
20 pins
8 Bits
5V power supplies
CY74FCT374ATPC Applications
There are a lot of Texas Instruments CY74FCT374ATPC Flip Flops applications.
- Divide a clock signal by 2 or 4
- Memory
- ESD performance
- Data Synchronizers
- Frequency Dividers
- ATE
- Clock pulse
- Patented noise
- Single Up Count-Control Line
- Pattern generators
