ISO122U Overview

Op amp is packaged in 28-SOIC (0.295, 7.50mm Width), 8 Leads case. A Isolation-type buffer amplifier is shown here. Instrumentation amplifier is delivered in a Tube case. The number of terminations is approaching the 28 mark. A total of 28 pins are located on this board. Please take in mind that this instrumentation amplifier should be run at 15V. 8 pins are located on the operational amplifiers. As far as the input offset voltage is concerned, linear amplifier rates at 20mV. Surface Mount is the recommended mounting type of operational amplifiers. It is recommended that this op amp ic be operated at a temperature no higher than -25°C~85°C for optimal performance. As long as the supply current of the chip does not exceed 5mA, this op amp ic can operate. You should keep the voltage gain at 0dB for the time being. On the buffer amps, there are 1 channels that can be used. In order for the buffer amplifier resistance to remain within the 200kOhm range, the device should be tested.

ISO122U Features

28 Pins
supply voltage of 15V
0dB voltage gain
Resistance of 200kOhm

ISO122U Applications

There are a lot of Texas Instruments ISO122U Instrumentational OP Amps applications.

• Power transmission
• MP3
• High gain DC amplifier
• Radar
• Biopotential
• pH (acidity)
• Car stereo
• Polarized electrodes
• Hand-held batteries
• Medical imaging