LMV932IDE4 Overview
Packaged in a 8-SOIC (0.154, 3.90mm Width) case, the buffer op amp is ready to use. General Purpose-type instrumentation amplifiers are used in this application. The op amp is delivered to you in a Tube case. The number of terminations is approaching the 8 mark. A total of 8 pins are attached to buffer op amp. It would be helpful if you could remember that this op amp ic should be powered by an 1.8V battery. It should be noted that this type of buffer amplifier is exactly what is known as a Operational Amplifier device. The op amp ic has an array of 8 pins on it. As far as the input offset voltage is concerned, linear amplifier rates at 1mV. Surface Mount is the recommended mounting type of operational amplifiers. In terms of operating temperature, this instrumentation amplifier is well suited to a temperature range of -40°C~125°C. Using a supply current of 116μA , this buffer op amp will be able to operate. There should be no change in the voltage gain at 100dB. This op amp ic has 2 circuits. There are more than a few advantages to using this instrumentation amplifier, one of which is that it outputs Rail-to-Rail signals. The operating supply voltage of the buffer op amp is rated at 5V.
LMV932IDE4 Features
8 Pins
supply voltage of 1.8V
100dB voltage gain
Output Type: Rail-to-Rail
LMV932IDE4 Applications
There are a lot of Texas Instruments LMV932IDE4 Instrumentational OP Amps applications.
- single/dual op amp sum and difference circuits
- Displayers for aircraft and air transportation control systems
- Test equipment
- Power control
- Gaming industry
- Tablets
- Hand-held batteries
- Mobile phone
- Test and measurement instruments
- Inverse/same-phase proportional circuit
