OPA2345UA Overview

The linear amplifier is packaged in a 8-SOIC (0.154, 3.90mm Width) case which makes it easy for the consumer to handle. An op amp of this type is a General Purpose-type. There is a Tube case that is delivered with the instrumentation amplifiers. There is a growing number of terminations approaching the number of 8. A total of 8 pins are located on this board. I would like you to keep in mind that this buffer amplifier needs to be run at a voltage of 5.5V. This particular linear amplifier is a type of Operational Amplifier device, to be precise. 8 pins are available on the instrumentation amplifier. In terms of the input offset voltage, instrumentation amplifier rates at 1mV. For this electronic part, it is recommended that you mount it with type Surface Mount. In terms of operating temperature, this instrumentation amplifier is well suited to a temperature range of -40°C~85°C. An 150μA volt supply current is needed for this linear amplifier to operate. You should keep the voltage gain at 122dB for the time being. Buffer op amp is equipped with 2 channels on the device. There are more than a few advantages to using this instrumentation amplifier, one of which is that it outputs Rail-to-Rail signals. MicroAmplifier? corresponds to the op amp's series.

OPA2345UA Features

8 Pins
supply voltage of 5.5V
122dB voltage gain
Output Type: Rail-to-Rail

OPA2345UA Applications

There are a lot of Texas Instruments OPA2345UA Instrumentational OP Amps applications.

• Test and measurement instruments
• pH (acidity)
• Displayers for aircraft and air transportation control systems
• Gaming industry
• Communication
• Power control
• Television
• Mobile phone
• Weak signal detection
• RF cable systems