OPA4241UA/2K5 Overview

In order to protect the op amps, a 14-SOIC (0.154, 3.90mm Width) case is used. A General Purpose-type buffer amplifier is shown here. The case in which buffer amplifier is delivered is called a Tape & Reel (TR) case. During the past two weeks, there have been close to 14 terminations. A total of 14 pins are located on this board. Please take in mind that op amp should be run at 5V. In more specific terms, this linear amplifier can be categoriOperational Amplifiered as a Operational Amplifier-type device. 14 pins are included on the operational amplifiers. As far as the input offset voltage is concerned, linear amplifier rates at 250μV. Surface Mount is the recommended mounting type of operational amplifiers. It is important to note that this linear amplifier works well at a temperature of -40°C~85°C when it comes to operating temperatureIn order for this instrumentation amplifier to operate, the supply current needs to be between 27μA and 10 . The voltage gain should stay at 120dB. There are more than a few advantages to using this instrumentation amplifier, one of which is that it outputs Rail-to-Rail signals. The linear amplifier consists of 4 different elements in total. The operating supply voltage of the buffer op amp is rated at 18V. A TR-shaped amplifier is used to pack the buffer amps.

OPA4241UA/2K5 Features

14 Pins
supply voltage of 5V
120dB voltage gain
Output Type: Rail-to-Rail

OPA4241UA/2K5 Applications

There are a lot of Texas Instruments OPA4241UA/2K5 Instrumentational OP Amps applications.

• Test equipment
• Strain gauges
• Inverse/same-phase proportional circuit
• single/dual op amp sum and difference circuits
• Automotive sensors
• Signal filtering
• Measurements of Wheatstone bridge
• earphone
• High input resistance broadband
• Semiconductor detectors