OPA4340EA/250G4 Overview

Packaged in a 16-SSOP (0.154, 3.90mm Width) case, the buffer op amp is ready to use. Op amps are General Purpose types of amplifier on the chip. The case in which buffer amplifier is delivered is called a Tape & Reel (TR) case. There have been a total of 16 terminations over the past year. Buffer amplifier has a total of 16 pins on it. This linear amplifier should be powered by an 5V battery. It should be noted that this type of buffer amplifier is exactly what is known as a Operational Amplifier device. 16 pins are located on the operational amplifiers. As far as the input offset voltage is concerned, linear amplifier rates at 500μV. This electronic part is recommended for mounting type Surface Mount. It is important to note that this linear amplifier works well at a temperature of -40°C~85°C when it comes to operating temperatureYou should keep the voltage gain at 124dB for the time being. Instrumentation amplifier has 4 channels on it. One of the many advantages that this linear amplifier has, among many other things, is the fact that it outputs Rail-to-Rail signals. A TR-shaped amplifier is used to pack the buffer amps. A supply of 750μA or higher is recommended for use with this electronic part. MicroAmplifier? is the number that corresponds to the series of the buffer op amp.

OPA4340EA/250G4 Features

16 Pins
supply voltage of 5V
124dB voltage gain
Output Type: Rail-to-Rail

OPA4340EA/250G4 Applications

There are a lot of Texas Instruments OPA4340EA/250G4 Instrumentational OP Amps applications.

• Large motor controllers
• Automatic control
• PDA
• Exponential operation circuits
• Measurements of Wheatstone bridge
• Television broadcasting equipment
• Image computer boards
• Inverse/same-phase proportional circuit
• Signal operation
• Blood pressure sensors