SN74AC374DWR Overview

It is embeded in 20-SOIC (0.295, 7.50mm Width) case. A package named Cut Tape (CT)includes it. Tri-State, Non-Invertedis the output configured for it. JK flip flop uses Positive Edgeas the trigger. This electronic part is mounted in the way of Surface Mount. A supply voltage of 2V~6V is required for operation. A temperature of -40°C~85°C TAis used in the operation. This logic flip flop is classified as type D-Type. It belongs to the 74ACseries of FPGAs. Its output frequency should not exceed 155MHz. D latch consists of 1 elements. There is 4μA quiescent consumption. 20terminations have occurred. JK flip flop belongs to 74AC374 family. A voltage of 3.3V is used to power it. Its input capacitance is 4.5pF farads. It belongs to the family of electronic devices known as AC. This electronic part is mounted in the way of Surface Mount. This board is designed with 20pins on it. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. There is a FF/Latchesbase part number assigned to the RS flip flops. The design is based on 8bits. 6Vis the maximum supply voltage (Vsup). For normal operation, the supply voltage (Vsup) should be kept above 2V. The superior flexibility of this circuit is achieved by using 8 circuits. As a result of its reliability, this D flip flop is ideally suited for TR. A total of 2ports are embedded in the D flip flop. With an output current of 24mA, it is possible to design the device in any way you want. Currently, there are 3 input lines present.

SN74AC374DWR Features

Cut Tape (CT) package
74AC series
20 pins
8 Bits

SN74AC374DWR Applications

There are a lot of Texas Instruments SN74AC374DWR Flip Flops applications.

• Instrumentation
• Bus hold
• Communications
• Convert a momentary switch to a toggle switch
• Counters
• Differential Individual
• Shift registers
• CMOS Process
• Buffer registers
• Test & Measurement