SN74ACT534DBRE4 Overview

20-SSOP (0.209, 5.30mm Width)is the way it is packaged. The package Tape & Reel (TR)contains it. This output is configured with Tri-State, Inverted. It is configured with a trigger that uses a value of Positive Edge. Surface Mountis in the way of this electric part. The JK flip flop operates at a voltage of 4.5V~5.5V. A temperature of -40°C~85°C TAis considered to be the operating temperature. This logic flip flop is classified as type D-Type. In terms of FPGAs, it belongs to the 74ACT series. It should not exceed 100MHzin terms of its output frequency. D latch consists of 1 elements. This process consumes 4μA quiescents. There have been 20 terminations. It is a member of the 74ACT534 family. An input voltage of 5Vpowers the D latch. A JK flip flop with a 4.5pFfarad input capacitance is used here. In this case, the D flip flop belongs to the ACTfamily. In this case, the electronic component is mounted in the way of Surface Mount. This board has 20 pins. Its clock edge trigger type is Positive Edge. It is part of the FF/Latchesbase part number family. 8bits are used in its design. Vsup reaches 5.5V, the maximal supply voltage. If you want to maintain normal operation, you should keep the supply voltage (Vsup) above 4.5V. Using 8 circuits, it is highly flexible. In light of its reliable performance, this T flip flop is well suited for TAPE AND REEL. A power supply of 5Vis required to operate it. There are 2 ports embedded in the flip flops. As a result of its output current of 24mA, it is very flexible in terms of design. It is reported that there are 3 input lines.

SN74ACT534DBRE4 Features

Tape & Reel (TR) package
74ACT series
20 pins
8 Bits
5V power supplies

SN74ACT534DBRE4 Applications

There are a lot of Texas Instruments SN74ACT534DBRE4 Flip Flops applications.

• EMI reduction circuitry
• Common Clocks
• Computers
• Memory
• Circuit Design
• Buffered Clock
• Test & Measurement
• Single Down Count-Control Line
• Frequency Divider circuits
• Balanced 24 mA output drivers