SN74ACT534DWR Overview
In the form of 20-SOIC (0.295, 7.50mm Width), it has been packaged. You can find it in the Tape & Reel (TR)package. The output it is configured with uses Tri-State, Inverted. JK flip flop uses Positive Edgeas the trigger. The electronic part is mounted in the way of Surface Mount. A supply voltage of 4.5V~5.5V is required for operation. A temperature of -40°C~85°C TAis considered to be the operating temperature. It is an electronic flip flop with the type D-Type. FPGAs belonging to the 74ACTseries contain this type of chip. In order for it to function properly, its output frequency should not exceed 100MHz. In total, there are 1 elements. It consumes 4μA of quiescent current without being affected by external factors. There have been 20 terminations. This D latch belongs to the family of 74ACT534. It is powered by a voltage of 5V . A 4.5pFfarad input capacitance is provided by this T flip flop. In this case, the D flip flop belongs to the ACTfamily. It is mounted in the way of Surface Mount. This board has 20 pins. This device exhibits a clock edge trigger type of Positive Edge. This part is included in FF/Latches. An electronic part with 8bits has been designed. Using 8 circuits, it is highly flexible. In light of its reliable performance, this T flip flop is well suited for TR. It runs on 5Vvolts of power. The flip flop contains 2ports. It is recommended that the supply voltage be kept at 5Vto maximize efficiency. In addition to its maximum design flexibility, the output current of the T flip flop is 24mA. This input has 3lines in it.
SN74ACT534DWR Features
Tape & Reel (TR) package
74ACT series
20 pins
8 Bits
5V power supplies
SN74ACT534DWR Applications
There are a lot of Texas Instruments SN74ACT534DWR Flip Flops applications.
- Latch-up performance
- Consumer
- Convert a momentary switch to a toggle switch
- Guaranteed simultaneous switching noise level
- Computing
- Instrumentation
- Memory
- Patented noise
- Matched Rise and Fall
- ATE
