SN74ACT74DBR Overview

As a result, it is packaged as 14-SSOP (0.209, 5.30mm Width). It is included in the package Cut Tape (CT). There is a Differentialoutput configured with it. This trigger uses the value Positive Edge. Surface Mountis in the way of this electric part. A voltage of 4.5V~5.5Vis used as the supply voltage. -40°C~85°C TAis the operating temperature. D-Typeis the type of this D latch. JK flip flop is a part of the 74ACTseries of FPGAs. Its output frequency should not exceed 210MHz Hz. As a result, it consumes 2μA quiescent current. Terminations are 14. JK flip flop belongs to 74ACT74 family. A voltage of 5V provides power to the D latch. The input capacitance of this T flip flop is 3pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. Devices in the ACTfamily are electronic devices. It is mounted in the way of Surface Mount. There are 14pins on it. The clock edge trigger type for this device is Positive Edge. It is included in FF/Latches. The superior flexibility is achieved through the use of 2 circuits. Compared to other similar T flip flops, this device offers reliable performance and is well suited for TR. The power supply is 5V. For high efficiency, the supply voltage should be kept at 5V. As a result of its output current of 24mA, it is very flexible in terms of design. This input has 4lines.

SN74ACT74DBR Features

Cut Tape (CT) package
74ACT series
14 pins
5V power supplies

SN74ACT74DBR Applications

There are a lot of Texas Instruments SN74ACT74DBR Flip Flops applications.

• Guaranteed simultaneous switching noise level
• ESD protection
• Shift registers
• ESD performance
• Single Up Count-Control Line
• Bounce elimination switch
• ESCC
• Event Detectors
• Cold spare funcion
• Data transfer