SN74AHC594D Overview

16-SOIC (0.154, 3.90mm Width) package contains the device. This chip has a total termination count of 16. A Tube case is used to pack it. There is 3.3V operating supply voltage listed on the part. It is equipped with a pin count of 16. Surface Mount is recommended for mounting. An electronic component is included in the AHC/VHC/H/U/V. Surface Mount is the way in which this component is mounted. A temperature range of -40°C~125°C is used for the operating environment. During operation, the voltage is within the range of 2V~5.5V. This electrical component belongs to the 74AHC series. By using the 74AHC594 family, you can find similar parts. The following additional elements are important to note: PARALLEL OUTPUT IS REGISTERED; UNREGISTERED SERIAL OUTPUT AVAILABLE. This part must have a minimum supply voltage (Vsup) of 2V. This device has 1 input lines available. A device capable of delivering voltage at 2/6V can be used. This part should not have a supply voltage (Vsup) greater than 5.5V. It is necessary to operate 9 output lines. 115MHz is the device's frequency.

SN74AHC594D Features

With 16 pins
Mounted in Surface Mount type.
Based on 74AHC594 family
It supplies 2/6V power
With 9 output lines

SN74AHC594D Applications

There are a lot of Texas Instruments SN74AHC594D Shift Registers applications.

• Interconnectors
• temporary data storage
• Counter
• Data manipulation
• Delay Line
• LED matrix control
• data transfer
• Flash Memory
• data manipulation
• Remote control holding register