SN74AHCT273DGVRE4 Overview
The flip flop is packaged in 20-TFSOP (0.173, 4.40mm Width). You can find it in the Tape & Reel (TR)package. As configured, the output uses Non-Inverted. The trigger it is configured with uses Positive Edge. There is an electrical part that is mounted in the way of Surface Mount. With a supply voltage of 4.5V~5.5V volts, it operates. In this case, the operating temperature is -40°C~85°C TA. It is an electronic flip flop with the type D-Type. The 74AHCTseries comprises this type of FPGA. This D flip flop should not have a frequency greater than 75MHz. There are 1 elements in it. There is 4μA quiescent consumption. In 20terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. D latch belongs to the 74AHCT273 family. The power supply voltage is 5V. This T flip flop has a capacitance of 2.5pF farads at the input. This D flip flop belongs to the family of AHCT/VHCT/VT. The electronic part is mounted in the way of Surface Mount. This board has 20 pins. This device's clock edge trigger type is Positive Edge. This device is part of the FF/Latchesbase part number family. There are 8bits in this flip flop. 8 circuits are used to achieve its superior flexibility. In view of its reliability, this D flip flop is a good fit for TR. A total of 5V power supplies are needed to run it. In order to achieve high efficiency, the supply voltage should be maintained at 5V. A total of 3input lines have been provided.
SN74AHCT273DGVRE4 Features
Tape & Reel (TR) package
74AHCT series
20 pins
8 Bits
5V power supplies
SN74AHCT273DGVRE4 Applications
There are a lot of Texas Instruments SN74AHCT273DGVRE4 Flip Flops applications.
- Shift Registers
- Set-reset capability
- Computing
- ATE
- Buffer registers
- Bus hold
- Buffered Clock
- Load Control
- Supports Live Insertion
- Counters
