SN74AHCT374NSRE4 Overview
The flip flop is packaged in a case of 20-SOIC (0.209, 5.30mm Width). You can find it in the Tape & Reel (TR)package. Tri-State, Non-Invertedis the output configured for it. This trigger is configured to use Positive Edge. There is an electronic component mounted in the way of Surface Mount. Powered by a 4.5V~5.5Vvolt supply, it operates as follows. It is operating at -40°C~85°C TA. This logic flip flop is classified as type D-Type. JK flip flop is a part of the 74AHCTseries of FPGAs. Its output frequency should not exceed 130MHz Hz. A total of 1elements are contained within it. As a result, it consumes 4μA of quiescent current without being affected by external factors. There have been 20 terminations. D latch belongs to the 74AHCT374 family. It is powered by a voltage of 5V . This JK flip flop has a 4pFfarad input capacitance. It is a member of the AHCT/VHCT/VTfamily of D flip flop. A part of the electronic system is mounted in the way of Surface Mount. It is designed with 20 pins. A Positive Edgeclock edge trigger is used in this device. There is a base part number FF/Latchesfor the RS flip flops. It reaches 5.5Vwhen the supply voltage is maximal (Vsup). Normally, the supply voltage (Vsup) should be kept above 4.5V. As a result of its reliability, this D flip flop is ideally suited for TAPE AND REEL. The power supply is 5V. A total of 2ports are embedded in the D flip flop. This input has 3lines.
SN74AHCT374NSRE4 Features
Tape & Reel (TR) package
74AHCT series
20 pins
5V power supplies
SN74AHCT374NSRE4 Applications
There are a lot of Texas Instruments SN74AHCT374NSRE4 Flip Flops applications.
- Digital electronics systems
- Divide a clock signal by 2 or 4
- Registers
- Modulo – n – counter
- Control circuits
- Single Up Count-Control Line
- Consumer
- EMI reduction circuitry
- Storage registers
- Differential Individual
