SN74AHCT574DBR Overview

The flip flop is packaged in a case of 20-SSOP (0.209, 5.30mm Width). It is included in the package Cut Tape (CT). In the configuration, Tri-State, Non-Invertedis used as the output. Positive Edgeis the trigger it is configured with. In this case, the electronic component is mounted in the way of Surface Mount. The supply voltage is set to 4.5V~5.5V. A temperature of -40°C~125°C TAis considered to be the operating temperature. This electronic flip flop is of type D-Type. The FPGA belongs to the 74AHCT series. This D flip flop should not have a frequency greater than 115MHz. In total, it contains 1 elements. Despite external influences, it consumes 4μAof quiescent current. A total of 20terminations have been recorded. It is a member of the 74AHCT574 family. The power supply voltage is 5V. The input capacitance of this T flip flop is 3pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. Devices in the AHCT/VHCT/VTfamily are electronic devices. In this case, the electronic component is mounted in the way of Surface Mount. A total of 20pins are provided on this board. In this device, the clock edge trigger type is Positive Edge. There is a base part number FF/Latchesfor the RS flip flops. There are 8bits in this flip flop. The superior flexibility is achieved through the use of 8 circuits. Considering the reliability of this T flip flop, it is well suited for TR. It runs on 5Vvolts of power. There are 2 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. Currently, there are 3 input lines present.

SN74AHCT574DBR Features

Cut Tape (CT) package
74AHCT series
20 pins
8 Bits
5V power supplies

SN74AHCT574DBR Applications

There are a lot of Texas Instruments SN74AHCT574DBR Flip Flops applications.

• Communications
• Shift Registers
• Safety Clamp
• Cold spare funcion
• Frequency Dividers
• Circuit Design
• Memory
• Latch
• Supports Live Insertion
• Data transfer