SN74AS4374BDWRE4 Overview
The package is in the form of 20-SOIC (0.295, 7.50mm Width). You can find it in the Tape & Reel (TR)package. T flip flop uses Tri-State, Non-Invertedas the output. It is configured with a trigger that uses a value of Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. A supply voltage of 4.5V~5.5V is required for operation. It is operating at a temperature of 0°C~70°C TA. This D latch has the type D-Type. It is a type of FPGA belonging to the 74AS series. This D flip flop should not have a frequency greater than 125MHz. In total, there are 1 elements. During its operation, it consumes 150mA quiescent energy. A total of 20terminations have been recorded. The 74AS4374 family contains this object. The power supply voltage is 5V. This D flip flop belongs to the family of AS. In this case, the electronic component is mounted in the way of Surface Mount. A total of 20pins are provided on this board. There is a clock edge trigger type of Positive Edgeon this device. The part is included in FF/Latches. This D flip flop is well suited for TAPE AND REEL based on its reliable performance. A total of 5V power supplies are needed to run it. The flip flop has 2embedded ports. If high efficiency is desired, the supply voltage should be kept at 5V. In addition to its maximum design flexibility, the output current of the T flip flop is 48mA. 3input lines are available for you to choose from. In addition, you can refer to the additinal DUAL-RANK FLIP-FLOP of the D latch.
SN74AS4374BDWRE4 Features
Tape & Reel (TR) package
74AS series
20 pins
5V power supplies
SN74AS4374BDWRE4 Applications
There are a lot of Texas Instruments SN74AS4374BDWRE4 Flip Flops applications.
- Cold spare funcion
- Clock pulse
- Shift registers
- Differential Individual
- CMOS Process
- Set-reset capability
- Count Modes
- Latch-up performance
- Common Clocks
- Memory
