SN74AS874DWRE4 Overview
The package is in the form of 24-SOIC (0.295, 7.50mm Width). Package Tape & Reel (TR)embeds it. As configured, the output uses Tri-State, Non-Inverted. The trigger configured with it uses Positive Edge. Surface Mountis positioned in the way of this electronic part. The supply voltage is set to 4.5V~5.5V. It is operating at 0°C~70°C TA. This electronic flip flop is of type D-Type. It belongs to the 74ASseries of FPGAs. You should not exceed 125MHzin the output frequency of the device. A total of 2elements are contained within it. There is 133mA quiescent consumption. Currently, there are 24 terminations. The 74AS874 family contains it. A voltage of 5V is used to power it. In this case, the D flip flop belongs to the ASfamily. In this case, the electronic component is mounted in the way of Surface Mount. The 24pins are designed into the board. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. This device has the base part number FF/Latches. Vsup reaches 5.5V, the maximal supply voltage. In view of its reliability, this D flip flop is a good fit for TAPE AND REEL. The D latch operates on 5V volts. The flip flop has 2embedded ports. It offers maximum design flexibility with its output current of 48mA. It is designed with 1 output lines. In addition, you can refer to the additinal WITH CLEAR of the D latch.
SN74AS874DWRE4 Features
Tape & Reel (TR) package
74AS series
24 pins
5V power supplies
SN74AS874DWRE4 Applications
There are a lot of Texas Instruments SN74AS874DWRE4 Flip Flops applications.
- Balanced 24 mA output drivers
- Guaranteed simultaneous switching noise level
- Communications
- Bounce elimination switch
- Convert a momentary switch to a toggle switch
- Storage Registers
- Cold spare funcion
- Common Clocks
- Digital electronics systems
- Count Modes
