Presented in 8-VFSOP (0.091, 2.30mm Width), this electrical component is convenient for overseas shipping. High reliability is provided by advanced packaging method Tape & Reel (TR). In Surface Mount, you'll find this switch device. Multiplexers and demultiplexers have a number of circuits 2:1. The operating temperature is extended to around -40°C~85°C TA. Total terminations are 8. By its 2 channels, the electronic component provides high-quality output. Turning on and running the electrical part should be easy with a 1.1V voltage supply. A total of 8 pins are injected into the electrical part body. Circuits based on SPDT switching are used to construct these analog switch ics. A 1 circuit is present in this switch device. Try searching for the analog switch ic with 74AUC2G53 if you are looking for variants. In this multiplexer, the internal resistance is 15Ohm. To find out what the functions of 8 pins are, please refer to their datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 2.7V. Analogue multiplexers of the Single supply type that are cost-effective. 800mV is the lowest voltage the electrical component should receive. This multiplexer would work with 10μA current. A voltage of 0.8V~2.7V is required to drain this analog switch from a single voltage supply. If put voltage greater than 10μA on the device, damage may be caused to the analogue multiplexer. This analog switch ic utilizes SEPARATE OUTPUT output. The electrical component supports 2 inputs. 198MHz bandwidths enable data to be transferred.