SN74HCT374DWRE4 Overview
The flip flop is packaged in a case of SOIC. You can find it in the Tape & Reel (TR)package. Terminations are 20. The power source is powered by 5V. Electronic devices of this type belong to the HCTfamily. Electronic part Surface Mountis mounted in the way. With its 20pins, it is designed to work with most electronic flip flops. In this device, the clock edge trigger type is Positive Edge. This device is part of the FF/Latchesbase part number family. The design is based on 8bits. Its flexibility is enhanced by 8 circuits. Due to its reliability, this T flip flop is well suited for TR. The D latch runs on a voltage of 5V volts. The D flip flop has no ports embedded. In order to ensure high efficiency, the supply voltage should remain at 5V. To operate, the chip has a total of 1 output lines. This input has 3lines in it. It is set to -6mAfor the high level output current. It is set to 6mAfor the low level output current. If the operating temperature is lower than 85°C, it is recommended. It should be higher than -40°Cwhen the system is operating. Normally, it operates with a voltage of 4.5VV as its minimum supply voltage. It supports a maximum supply voltage of 5.5V volts. This frequency can be achieved 40MHz. In this case, it uses a BUS DRIVER logic IC. It is equipped with 1 functions . The D latch is equipped with 20 pins.
SN74HCT374DWRE4 Features
Tape & Reel (TR) package
20 pins
8 Bits
5V power supplies
1 Functions
20 pin count
SN74HCT374DWRE4 Applications
There are a lot of Texas Instruments
SN74HCT374DWRE4 Flip Flops applications.
- Data storage
- Data transfer
- Latch
- Registers
- Memory
- Frequency division
- Memory
- Event Detectors
- Data Synchronizers
- Asynchronous counter
