Shipping overseas is convenient due to the electrical component's packing in 16-TFSOP (0.173, 4.40mm Width). High reliability is achieved by using advanced packaging method Cut Tape (CT). The multiplexer is located in Surface Mount. There is 4:1 ratio between the number of multiplexers and demultiplexers. Increasing operating temperature to around -40°C~85°C TA. Totally, there are 16 terminations. As a result of its 2 channels, this electronic component provides high-quality output. Turning on and running the electrical part should be easy with a 2.5V voltage supply. There is an electrical component included in the 16 series. These analog multiplexers are built based on SP4T switching circuits. Circuits number 2 make up this analogue multiplexer. 74LV4052 can be used to search for analog multiplexer variants. It has an internal resistance of 100Ohm. You can find the functions of the 16 pins in the datasheets. The analogue multiplexer in this example is a typical Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 5.5V. The digital multiplexer has a low cost Single supply. 2V should be the lowest voltage fed to the electronic component. For this digital switch to work, 20μA current would suffice. The voltage required by this switch device is 2V~5.5V, draining from a single voltage supply. Integrated with an analog IC DIFFERENTIAL MULTIPLEXER. The electrical component supports 8 inputs. The data can be transferred over a wide range of bandwidths, called 50MHz bandwidths. 4-bit conductivity is possible.