The electronic component is convenient to ship overseas because it is packed in a 16-TSSOP (0.173, 4.40mm Width). Advanced packaging method Tube is used to provide high reliability. The multiplexer is located in Surface Mount. Multiplexers and demultiplexers have a number of circuits 4:1. Operating temperature around -40°C~85°C TA extended. The total number of terminations is 16. High-quality output is provided by the electronic component's 2 channels. A 2.5V voltage supply should turn on and run the electronic component. There is an electrical component included in the 16 series. Unlike digital switches, these are based on SP4T switching circuits. This multiplexer is composed of 2 circuits. Try searching for 74LV4052 variants of the analog switch ic. Internally, this switch multiplexer has a resistance of 100Ohm. Datasheets for 16 pin functions are available upon request. The analog multiplexer shown here is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 5.5V. Analog switch ics with Single supply type are cost-effective. The lowest voltage fed to the electronic component should be 2V. The switch device would be able to operate with 20μA current. The voltage required by this switch device is 2V~5.5V, draining from a single voltage supply. This product is integrated with an analog integrated circuit (IC) of type DIFFERENTIAL MULTIPLEXER. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer. A 8 input needs to be operated. It is possible to transfer data over a 50MHz-bandwidth. Drain to Source resistance for this electronic component is 100Ohm. It can conduct in a 4-bit manner.