The electronic component is convenient to ship overseas because it is packed in a 6-XFDFN. The advanced packaging method Tape & Reel (TR) provides high reliability. In Surface Mount, this analog switch is mounted. 2:1 is the number of circuits in the multiplexer and demultiplexer. Temperatures around -40°C~85°C TA are extended for operation. In total, 6 terminations have occurred. This electronic part offers high-quality output due to its 1 channels. An 2.3V voltage supply should allow the electrical part to be turned on and run. As part of the design of the 6 series, this electronic part has been incorporated into the system. SPDT switching circuits are used in these analog switch ics. There are 1 circuits in this multiplexer. Try searching for the analog switch ic with 74LVC1G3157 if you are looking for variants. It has an internal resistance of 15Ohm. Datasheets for 6 pin functions are available upon request. The analog multiplexer shown here is a typical Multiplexers or Switches. Users shouldn't supply more than 5.5V voltage to the switch device. An effective Single supply digital multiplexer. It is recommended to use 1.65V as the lowest voltage for the electrical part. 1μA current would be enough for this multiplexer to operate. A voltage of 1.65V~5.5V is required to drain this analog switch from a single voltage supply. Put voltage above 10μA on the multiplexer to cause damage. It is possible to transfer data over a 340MHz-bandwidth. An output of 2 is provided by the digital multiplexer.