The electrical component comes in 8-LSSOP, 8-MSOP (0.110, 2.80mm Width) packaging, which makes it convenient to ship overseas. A high level of reliability can be achieved through the use of an advanced packaging method Cut Tape (CT). This analog switch is mounted in Surface Mount. Multiplexers and demultiplexers have the same number of circuits 2:1. Operating temperature extended to -40°C~85°C TA. 8 terminations have been made so far. By its 2 channels, the electronic component provides high-quality output. When a voltage supply of 2.3V is used, the electronic component should be turned on and run. An electrical component like this is included in the 8 series. Multiplexers built on a SPDT switching circuit are built. There are 1 circuits in this switch device. Try searching for 74LVC2G53 variants of the analog switch ic. There is 13Ohm internal resistance in this digital multiplexer. Datasheets for 8 pin functions are available upon request. It is a typical Multiplexers or Switches analog multiplexer. normally, users should not supply switches with voltages higher than 5.5V. A analog switch ic that has a cost-effective Single supply type. There should be 1.65V voltage fed to the electrical part below 1.65V. In order to operate this switch device, it would need a current of 1μA. A voltage of 1.65V~5.5V is required for this switch device, which drains from a single voltage source. A digital multiplexer may suffer damage if voltage is applied above 1μA. The analog switch ic utilizes COMMON OUTPUT outputs in total. In order to operate the 2 inputs, there are several steps to follow. This switch operates within the bandwidth of 300MHz.