The electronic part can be shipped overseas conveniently because it is packaged in 8-VFSOP (0.091, 2.30mm Width). High reliability is ensured by the advanced packaging method Cut Tape (CT). It is mounted in the position Surface Mount. 2:1 is the ratio of multiplexer to demultiplexer circuits. Extended operating temperature around -40°C~85°C TA. Total terminations are 8. By its 2 channels, the electronic component provides high-quality output. A 2.3V voltage supply should turn on and run the electronic component. The electronic part body is injected with 8 pins. Circuits based on SPDT switching are used to construct these analog switch ics. A total of 1 circuits make up this switch device. Use 74LVC2G53 to search for variants of the digital switches. As far as internal resistance is concerned, it has 13Ohm. You can find the functions of the 8 pins in the datasheets. There is a standard Multiplexers or Switches analogue multiplexer here. In normalcircumstances, users should not exceed 5.5V volts for the multiplexer. A cost-effective Single supply type analogue multiplexer. 1.65V is the lowest voltage that should be fed to the electronic electronic part. 1μA current would be enough for this multiplexer to operate. An analogue multiplexer drains from a single voltage supply at 1.65V~5.5V. Putting voltage greater than 1μA on the multiplexer may cause damage. There are 2 inputs to be operated. 300MHz bandwidths enable data to be transferred. Drain to Source resistance for this electronic component is 13Ohm.