SN74LVC2G53DCURE4 Overview

The electronic component is convenient to ship overseas because it is packed in a 8-VFSOP (0.091, 2.30mm Width). This packaging method provides high reliability because it uses advanced packaging techniques. The multiplexer is located in Surface Mount. Multiplexers and demultiplexers have a ratio of 2:1. Operating temperature around -40°C~85°C TA extended. Total terminations are 8. A electrical component with 2 channels is capable of high-quality output. When the electronic component is given a voltage of 2.3V, it should be turned on and run. A total of 8 pins are injected into the body of the electronic part. A SPDT switching circuit is used for these analog switches. There are 1 circuits in this multiplexer. Look for analog switch ic variants by searching with 74LVC2G53. There is 13Ohm internal resistance in this digital multiplexer. Datasheets for 8 pin functions are available upon request. A analogue multiplexer of this type is a Multiplexers or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 5.5V. A analog switch ic that has a cost-effective Single supply type. There should be 1.65V voltage fed to the electrical part below 1.65V. For this multiplexer to operate, 1μA current would be sufficient. Using only a single voltage supply, this analog switch requires 1.65V~5.5V voltage. If you put voltage higher than 1μA on the digital multiplexer, damage may occur. Operating the 2 inputs requires 2 inputs.

SN74LVC2G53DCURE4 Features

2 Channels
Switch Circuit: SPDT
1μA Supply Current
-3db Bandwidth: 300MHz

SN74LVC2G53DCURE4 Applications

There are a lot of Texas Instruments SN74LVC2G53DCURE4 Analog Switches & Multiplexers ICs applications.

• Cable Modem
• Audio and video switching
• Medical systems
• Fiber In The Loop (FITL)
• Battery Powered Systems
• Microwave transmission systems
• Video switching
• Automatic test equipment
• CSU
• RGB switches