SN74LVC823ANSRE4 Overview
As a result, it is packaged as 24-SOIC (0.209, 5.30mm Width). The package Tape & Reel (TR)contains it. In the configuration, Tri-State, Non-Invertedis used as the output. This trigger is configured to use Positive Edge. Surface Mountis positioned in the way of this electronic part. Powered by a 1.65V~3.6Vvolt supply, it operates as follows. It is operating at -40°C~85°C TA. The type of this D latch is D-Type. It belongs to the 74LVCseries of FPGAs. You should not exceed 150MHzin its output frequency. The element count is 1 . As a result, it consumes 10μA quiescent current. A total of 24 terminations have been made. You can search similar parts based on 74LVC823. It is powered from a supply voltage of 1.8V. Input capacitance of this device is 5pF farads. Devices in the LVC/LCX/Zfamily are electronic devices. It is mounted in the way of Surface Mount. This board has 24 pins. This device has the clock edge trigger type of Positive Edge. There is a base part number FF/Latchesfor the RS flip flops. Considering the reliability of this T flip flop, it is well suited for TAPE AND REEL. A total of 2ports are embedded in the D flip flop. In order to operate, the chip has 3 output lines. Additionally, you may refer to the D latch's additional WITH CLEAR AND CLOCK ENABLE.
SN74LVC823ANSRE4 Features
Tape & Reel (TR) package
74LVC series
24 pins
SN74LVC823ANSRE4 Applications
There are a lot of Texas Instruments SN74LVC823ANSRE4 Flip Flops applications.
- Balanced 24 mA output drivers
- Memory
- Shift registers
- ATE
- Single Down Count-Control Line
- Set-reset capability
- Guaranteed simultaneous switching noise level
- Convert a momentary switch to a toggle switch
- Bounce elimination switch
- Synchronous counter
