SN74S175D Overview

It is packaged in the way of 16-SOIC (0.154, 3.90mm Width). It is contained within the Tubepackage. T flip flop is configured with an output of Differential. In the configuration of the trigger, Positive Edgeis used. Surface Mountmounts this electrical part. A 4.75V~5.25Vsupply voltage is required for it to operate. The operating temperature is 0°C~70°C TA. A flip flop of this type is classified as a D-Type. JK flip flop is a part of the 74Sseries of FPGAs. Its output frequency should not exceed 110MHz Hz. A total of 1elements are contained within it. There is a consumption of 96mAof quiescent energy. 16terminations have occurred. Members of the 74S175family make up this object. An input voltage of 5Vpowers the D latch. Sis the family of this D flip flop. This electronic part is mounted in the way of Surface Mount. With its 16pins, it is designed to work with most electronic flip flops. This device exhibits a clock edge trigger type of Positive Edge. This RS flip flops is a part number FF/Latches. The flip flop is designed with 4bits. The superior flexibility of this circuit is achieved by using 4 circuits. It operates from 5V power supplies. If high efficiency is desired, the supply voltage should be kept at 5V. The 20mA output current allows it to be designed with the greatest amount of flexibility. To operate, the chip has a total of 2 output lines. The number of input lines is 3.

SN74S175D Features

Tube package
74S series
16 pins
4 Bits
5V power supplies

SN74S175D Applications

There are a lot of Texas Instruments SN74S175D Flip Flops applications.

• High Performance Logic for test systems
• Consumer
• Set-reset capability
• Count Modes
• Common Clocks
• Bus hold
• Communications
• Bounce elimination switch
• Matched Rise and Fall
• Test & Measurement