SN74S374DWRE4 Overview
The flip flop is packaged in 20-SOIC (0.295, 7.50mm Width). D flip flop is included in the Tape & Reel (TR)package. T flip flop is configured with an output of Tri-State, Non-Inverted. This trigger is configured to use Positive Edge. The electronic part is mounted in the way of Surface Mount. A supply voltage of 4.75V~5.25V is required for operation. A temperature of 0°C~70°C TAis used in the operation. It belongs to the type D-Typeof flip flops. This type of FPGA is a part of the 74S series. It should not exceed 100MHzin its output frequency. In total, it contains 1 elements. This process consumes 110mA quiescents. A total of 20terminations have been recorded. You can search similar parts based on 74S374. The power supply voltage is 5V. This D flip flop belongs to the family of S. There is an electronic part mounted in the way of Surface Mount. The 20pins are designed into the board. A Positive Edgeclock edge trigger is used in this device. The part is included in FF/Latches. As soon as Vsup reaches 5.25V, the maximum supply voltage is reached. Normally, the supply voltage (Vsup) should be above 4.75V. As a result of its reliable performance, this T flip flop is suitable for TAPE AND REEL. The D latch runs on a voltage of 5V volts. A total of 2ports are embedded in the D flip flop. 3input lines are available for you to choose from. -6.5mA is set as the high level output current. In the low level output current setting, 20mAis used.
SN74S374DWRE4 Features
Tape & Reel (TR) package
74S series
20 pins
5V power supplies
SN74S374DWRE4 Applications
There are a lot of Texas Instruments SN74S374DWRE4 Flip Flops applications.
- Balanced Propagation Delays
- Automotive
- 2 – Bit synchronous counter
- Buffered Clock
- Divide a clock signal by 2 or 4
- Convert a momentary switch to a toggle switch
- Frequency division
- Computers
- ESCC
- Supports Live Insertion
