TL062IDR Overview

There is a 8-SOIC (0.154, 3.90mm Width) case in which the instrumentation amplifier is packaged. An op amp of this type is a J-FET-type. Linear amplifier is delivered in a Cut Tape (CT) case. It is estimated that there will be at least 8 terminations this year. A total of 8 pins are located on this board. The linear amplifier should be run at 15V at all times, so please keep that in mind when using it. A type of Operational Amplifier op amp ic can be identified by the fact that this is a type of Operational Amplifier device. 8 pins are included on the operational amplifiers. Regarding input offset voltage, buffer amplifier rates 6mV voltage. For this electrical component, Surface Mount is the recommended mounting type. In relation to the operating temperature of this buffer op amp, it works well at an average of -40°C~85°C . It is possible to operate this buffer amplifier from a supply current of 200μA . 75.56dB should remain the voltage gain. There are a total of 2 channels available on the op amps. It is used TR to pack the op amps.

TL062IDR Features

8 Pins
supply voltage of 15V
75.56dB voltage gain

TL062IDR Applications

There are a lot of Texas Instruments TL062IDR Instrumentational OP Amps applications.

• Video data acquisition
• Switching amplifier
• Weighing systems
• Signal amplification
• Thermocouples
• RF cable systems
• PDA
• Integrator circuits
• Wireless base stations
• Video computer boards