TL074CDR Overview

A 14-SOIC (0.154, 3.90mm Width) case is used to package the op amp. J-FET-type instrumentation amplifiers are used in this application. The case in which buffer amplifier is delivered is called a Tape & Reel (TR) case. It is estimated that there will be 14 terminations in the next few months. There are a total of 14 pins on this op amp. It is important to remember that this op amp should be operated at a voltage of 15V volts. It should be noted that this op amp is a type of Operational Amplifier device. There are 14 pins on this chip. In terms of the input offset voltage, instrumentation amplifier rates at 10mV. It is recommended that this electronic component be mounted using the Surface Mount mounting type. In terms of operating temperature, this instrumentation amplifier performs well at a temperature of about 0°C~70°C . An 1.4mA volt supply current is needed for this linear amplifier to operate. There should be no change in the voltage gain. There are 4 channels on the operational amplifiers. The instrumentation amplifier is packed in the form of TR.

TL074CDR Features

14 Pins
supply voltage of 15V
106.02dB voltage gain

TL074CDR Applications

There are a lot of Texas Instruments
TL074CDR Instrumentational OP Amps applications.

• Addition operation circuits
• Subtraction operation circuits
• single/dual op amp sum and difference circuits
• Integrator circuits
• Differentiator circuits
• Logarithmic operation circuits
• Exponential operation circuits
• Multiplication circuits
• Division circuits
• Precision measurement