TLV2404CPW Overview

There is a 14-TSSOP (0.173, 4.40mm Width) case in which the instrumentation amplifier is packaged. General Purpose-type instrumentation amplifiers are used in this application. A Tube case is used to deliver the buffer op amp. A total of 14 terminations have been reported in the past few weeks. A total of 14 pins are located on this board. I would like to remind you that this buffer op amp should be powered by an 2.7V battery. Instrumentation amplifier is a part of Operational Amplifier. There are 14 pins on this chip. The input offset voltage is 1.2mV. It is recommended that this electronic component be mounted using the Surface Mount mounting type. It is recommended that this op amp ic be operated at a temperature no higher than 0°C~70°C for optimal performance. This op amp can operate from a supply current at 900nA. You should keep the voltage gain at 120dB for the time being. Buffer op amp is equipped with 4 channels on the device. One of its many advantages is that buffer op amp outputs Rail-to-Rail signals. The operating supply voltage of the buffer op amp is rated at 8V.

TLV2404CPW Features

14 Pins
supply voltage of 2.7V
120dB voltage gain
Output Type: Rail-to-Rail

TLV2404CPW Applications

There are a lot of Texas Instruments TLV2404CPW Instrumentational OP Amps applications.

• Hand-held batteries
• E-book readers
• Strain gauges
• Weak signal detection
• Integrator circuits
• Industrial applications including automation
• Switching amplifier
• Digital cameras
• Test and measurement instruments
• Instrumentation