TLV2404IPWG4 Overview

A TSSOP case is used to package the op amp. OPERATIONAL AMPLIFIER-type instrumentation amplifiers are used in this application. The case in which buffer amplifier is delivered is called a Rail/Tube case. It is estimated that there will be 14 terminations in the next few months. There are a total of 14 pins on this op amp. It is important to remember that this op amp should be operated at a voltage of 2.7V volts. It should be noted that this op amp is a type of Operational Amplifier device. There are 14 pins on this chip. In terms of the input offset voltage, instrumentation amplifier rates at 1.2mV. An 900nA volt supply current is needed for this linear amplifier to operate. Voltage gain should remain at 120dB. In order for op amp to function properly, the temperature should not be lower than -40°C degrees Celsius. It should only be used at temperatures up above 125°C. The buffer op amp is rated for an operating voltage of 4 when it comes to the power supply. The operating supply voltage of the buffer op amp is rated at 8V. I would like to point out that this electrical component is capable of working from a voltage below 16V as far as the power supply is concerned. As a general rule, it is advisable to keep the op amp's supply voltage above 2.5V at all times. The dual supply voltage of 8V should be used for the conduct of this electronic component.

TLV2404IPWG4 Features

14 Pins
supply voltage of 2.7V
120dB voltage gain

TLV2404IPWG4 Applications

There are a lot of Texas Instruments
TLV2404IPWG4 Instrumentational OP Amps applications.

• Addition operation circuits
• Subtraction operation circuits
• single/dual op amp sum and difference circuits
• Integrator circuits
• Differentiator circuits
• Logarithmic operation circuits
• Exponential operation circuits
• Multiplication circuits
• Division circuits
• Precision measurement