TLV2422MUB Overview

An op amp ic of the OPERATIONAL AMPLIFIER type. There is a growing number of terminations approaching the number of 10. The pins on this board total to 10 in total. I would like to remind you that this buffer op amp should be powered by an 3V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. A total of 10 pins are present on the instrumentation amplifier. 120dB should remain the voltage gain. As far as the device is concerned, buffer amplifier has 2 channels. For the buffer op amp to operate properly, it must be above the temperature of -55°C degrees Celsius. No temperature greater than 125°C should be used. For packing the buffer amplifier, the TUBE-axis is adopted. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 10V. A high supply voltage of more than 2.7V is recommended for the instrumentation amplifier's supply voltage. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 5V volts.

TLV2422MUB Features

10 Pins
supply voltage of 3V
120dB voltage gain

TLV2422MUB Applications

There are a lot of Texas Instruments
TLV2422MUB Instrumentational OP Amps applications.

• Integrator circuits
• Differentiator circuits
• Logarithmic operation circuits
• Exponential operation circuits
• Multiplication circuits
• Division circuits
• Precision measurement
• Power control
• Information processing
• Weak signal detection