TS3A4741DGKR Overview

Shipping overseas is convenient due to the electrical component's packing in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width). Advanced packaging method Tape & Reel (TR) is used to provide high reliability. There is an analog multiplexer mounted in position Surface Mount. Multiplexers and demultiplexers have the same number of circuits 1:1. Operating temperature extended to -40°C~85°C TA. A total of 8 terminations have been recorded. The electronic part delivers high-quality output through its 2 channels. A 1.8V voltage supply should turn on and run the electronic component. This electrical component is included in the 8 series of products. A SPST - NO switching circuit is used to build these analog multiplexers. Use TS3A4741 to search for variants of the digital switches. In this multiplexer, the internal resistance is 900mOhm. Please refer to the datasheets for 8 pins functions. Multiplexer or Switches is a typical switch device. In normalcircumstances, users should not exceed 3.6V volts for the multiplexer. The digital multiplexer has a low cost Single supply. The lowest voltage fed to the electronic component should be 1.65V. A voltage of 1.6V~3.6V is required for this switch device, which drains from a single voltage source. A voltage higher than 750nA may cause damage to the switch multiplexer. A total of SEPARATE OUTPUT outputs are available on this analog switch ic. It is possible to operate 2 inputs. 125MHz-bandwidths can be used to transfer data between multiplexers.

TS3A4741DGKR Features

2 Channels
Switch Circuit: SPST - NO
Bandwidth: 125MHz

TS3A4741DGKR Applications

There are a lot of Texas Instruments TS3A4741DGKR Analog Switches & Multiplexers ICs applications.

• Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
• Audio and video routing
• Microwave transmission systems
• Battery Powered Instruments
• Microprocessor controlled systems
• SONET/SDH ADM
• Avionics
• Multiplexers
• Medical
• Video switching