The electronic component is convenient to ship overseas because it is packed in a 16-SOIC (0.154, 3.90mm Width). This packaging method provides high reliability because it uses advanced packaging techniques. There is an analog multiplexer mounted in position Surface Mount. 4:1 is the ratio of multiplexer to demultiplexer circuits. Operation at a temperature around -40°C~85°C TA. Total terminations are 16. As a result of its 4 channels, this electronic component provides high-quality output. With a 2.5V voltage supply, the electrical component should be turned on and run. As part of its design, the 16 series is equipped with this electronic component. These analog multiplexers are built based on SP4T switching circuits. There are 2 circuits in this multiplexer. Look for analog switch ic variants by searching with TS3A5017. Internally, this switch multiplexer has a resistance of 12Ohm. The functions of 16 pins can be found in the datasheets. There is a standard Multiplexer or Switches analogue multiplexer here. In normalcircumstances, users should not exceed 3.6V volts for the multiplexer. Analog switch ics with Single supply type are cost-effective. It is recommended to use 2.3V as the lowest voltage for the electrical part. For this multiplexer to operate, 2.5μA current would be sufficient. Using only a single voltage supply, this analog switch requires 2.3V~3.6V voltage. It may damage the digital multiplexer if the voltage is higher than 7μA. This switch operates within the bandwidth of 165MHz. There is 12Ohm Drain to Source resistance on this electronic part. A analog switch ics with 8 outputs is included.