TS5A23157DGSRG4 Overview

Shipping overseas is convenient with the electronic component packed in 10-TFSOP, 10-MSOP (0.118, 3.00mm Width). In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. In Surface Mount, this analog switch is mounted. Multiplexer and demultiplexer circuits have a number 2:1. Temperatures around -40°C~85°C TA are extended for operation. 10 terminations have been made so far. This electronic part offers high-quality output due to its 2 channels. When the electronic component is given a voltage of 1.8V, it should be turned on and run. As part of the design of the 10 series, this electronic part has been incorporated into the system. SPDT switching circuits are used in these analog switch ics. There are 2 circuits in this switch device. Try searching with TS5A23157 if you're looking for variants. As far as internal resistance is concerned, it has 10Ohm. Datasheets for functions of 10 pins are available. A analogue multiplexer of this type is a Multiplexer or Switches. Users should never supply a voltage higher than 5.5V to a switch device. The analog switch ic is of the Single supply type and is cost-effective. It is recommended that the electrical component receives a voltage of 1.8V. In order to operate this switch device, it would need a current of 1μA. A voltage of 1.65V~5.5V is required to drain this analog switch from a single voltage supply. If you put voltage higher than 1μA on the digital multiplexer, damage may occur. Operating 2 inputs is required. In 220MHz-bandwidths, data can be transferred. Don’t miss additional features of the electronic component such as: VIDEO APPLICATION. The analog switch ics includes 4 outputs.

TS5A23157DGSRG4 Features

2 Channels
Switch Circuit: SPDT
1μA Supply Current
Bandwidth: 220MHz
Additional Features: VIDEO APPLICATION

TS5A23157DGSRG4 Applications

There are a lot of Texas Instruments TS5A23157DGSRG4 Analog Switches & Multiplexers ICs applications.

• T1/E1 Terminals
• Digital access cross connects
• Ultrasound
• E1 Network Equipment
• Audio and video signal routing
• Cell phones
• Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
• Digital Cross-Connects
• PCMCIA cards
• RGB switches