The electrical component comes in 10-TFSOP, 10-MSOP (0.118, 3.00mm Width) packaging, which makes it convenient to ship overseas. High reliability is achieved by using advanced packaging method Tape & Reel (TR). Multiplexers like this are mounted in the Surface Mount position. 2:1 is the ratio of multiplexer to demultiplexer circuits. Increasing operating temperature to around -40°C~85°C TA. In total, there have been 10 terminations. A high-quality output is provided by the electrical component's 2 channels. With a 1.8V voltage supply, the electrical component should be turned on and run. An electrical component of this type can be found in the 10 series. A SPDT switching circuit is used for these analog switches. Try searching with TS5A23160 to find analog multiplexer variants. As far as internal resistance is concerned, it has 900mOhm. For details about the functions of 10 pins, please refer to the datasheets. A analogue multiplexer of this type is a Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 5.5V. A cost-effective Single supply type analogue multiplexer. The lowest voltage the electronic part should receive is 1.65V. 10nA current would be enough for this multiplexer to operate. A voltage of 1.65V~5.5V is required to drain this analog switch from a single voltage supply. When the digital multiplexer is charged above 500nA, damage can occur. Operating the 2 inputs requires 2 inputs. A 95MHz-bandwidth can be used for data transfer. Drain to Source resistance is 900mOhm. 4 outputs are included in the analogue multiplexer.