Due to its 8-VFSOP (0.091, 2.30mm Width) packaging, the electronic part is convenient for international shipping. High reliability is achieved by using advanced packaging method Tape & Reel (TR). Mounted in Surface Mount is this multiplexer. Multiplexers and demultiplexers have the same number of circuits 1:1. Operation at a temperature around -40°C~85°C TA. A total of 8 terminations have been recorded. The electronic part delivers high-quality output through its 1 channels. Turning on and running the electrical part should be easy with a 1.8V voltage supply. Electronic part bodies are injected with 8 pins. SPST - NC switching circuits are used in these analog switch ics. TS5A23167 can be used to search for analog multiplexer variants. Internally, this switch multiplexer has a resistance of 900mOhm. You can find the functions of the 8 pins in the datasheets. A analogue multiplexer of this type is a Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 5.5V. Digital switch that provides Single power at a cost-effective price. In order for the electronic part to function properly, the lowest voltage should be 1.65V. The switch device would be able to operate with 10nA current. The voltage required by this switch device is 1.65V~5.5V, draining from a single voltage supply. It may damage the digital multiplexer if the voltage is higher than 100nA. The digital multiplexer has SEPARATE OUTPUT outputs that can be used. Operating 2 inputs is required. 150MHz bandwidths enable data to be transferred.