The electronic part can be shipped overseas conveniently because it is packaged in SOT-23-6. In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. Mounted in Surface Mount is this multiplexer. 2:1 is the ratio of multiplexer to demultiplexer circuits. Increasing operating temperature to around -40°C~85°C TA. In total, there are 6 terminations. As a result of its 1 channels, this electronic component provides high-quality output. Powered by a 1.8V voltage supply, the electrical part should be switched on and run. There are 6 pins injected into the electronic part body. The analog switch ics are built using SPDT switching circuits. Try searching for the analog switch ic with TS5A3160 if you are looking for variants. Analog switches have 1.1Ohm internal resistance. To find out what the functions of 6 pins are, please refer to their datasheets. There is a standard Multiplexer or Switches analogue multiplexer here. In normalcircumstances, users should not exceed 5.5V volts for the multiplexer. The digital multiplexer has a low cost Single supply. There should be 1.65V voltage fed to the electrical part below 1.65V. It would be sufficient to run this analogue multiplexer with 10nA current. Draining from a single voltage supply, this analog switch requires a voltage of 1.65V~5.5V. The analogue multiplexer may be damaged if voltage is greater than 50nA. Operating the 1 inputs requires 1 inputs. In 100MHz-bandwidths, data can be transferred. There is 1.1Ohm resistance between Drain and Source for this electronic part. The analog switch ics has 2 outputs.