Shipping overseas is convenient due to the electrical component's packing in 8-VFSOP (0.091, 2.30mm Width). High reliability is achieved by using advanced packaging method Tape & Reel (TR). It is mounted in the position Surface Mount. 3:1 is the ratio of multiplexer to demultiplexer circuits. Operational temperature extended around -40°C~85°C TA. A total of 8 terminations have been recorded. A high-quality output is provided by the electrical component's 3 channels. If the voltage supply is 1.8V volts, the electrical component should be turned on and run. A total of 8 pins are injected into the electrical part body. On the other hand, analog switches can be constructed using SP3T switching circuits. Try searching with TS5A3357 to find analog multiplexer variants. Internally, this switch multiplexer has a resistance of 15Ohm. Please refer to the datasheets for 8 pins functions. Multiplexer or Switches is a typical switch device. Users shouldn't supply more than 5.5V voltage to the switch device. Analog switch ics with Single supply type are cost-effective. It is recommended that the electrical component receives a voltage of 1.65V. This digital switch can be operated with a current of 1μA. An analogue multiplexer drains from a single voltage supply at 1.65V~5.5V. A voltage higher than 1μA may cause damage to the switch multiplexer. It is possible to operate 1 inputs. There are 334MHz bandwidths for data transfer. There are 3 outputs on the analogue multiplexer.
TS5A3357DCUTG4 Features
3 Channels Switch Circuit: SP3T 1μA Supply Current Bandwidth: 334MHz
TS5A3357DCUTG4 Applications
There are a lot of Texas Instruments TS5A3357DCUTG4 Analog Switches & Multiplexers ICs applications.
ADCs such as AD7840/8, AD7870/1/2/4/5/6/8
Intelligent PBX
Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads